ROBOT TO SWING SCALP AFTER DOJI/HAMMER DETECTED, START TODAY AND FINISH IN 3 DAYS.

Hi guys,

I av a simple robot job for you.

I need a competent programmer to create a robot that can identify any of the following reversal candles ;

(1) All types of Doji ,(2) Spinning tops , (3) Hammers, (4) Inverted hammers at 30minutes /1HR TIME FRAME CANDLES AT VALID SWING.

A valid swing would be confirmed by CCI overbought / oversold and the reversal candle must be rejecting on a SUPPORT/RESISTANT POINT.

Once a reversal candle is detected and that reversal candle is at a zig zag swing rejecting on a support / resistant line, it should open a pending order at the open of the next hour candle.Zig Zag helps to see the swings but it must be confirmed by CCI overbought/oversold and a support/resistant to make the swing a valid one.

For example, if a doji was detected at the server time of 8.00 and the doji is at a swing and it is rejecting on a support/resistant, then when the 9.00 hour candle opens, the robot should open a pending order .

The robot should have a trailing stop feature, a feature to set the percentage of capital to risk and risk/reward setting.

See sample charts below. Spinning top and hammer were spotted at a certain 1hr candle close before pending orders were opened when the next 1hr candle opened.

Please if you are too busy and or you have too many arbitrations, dont apply. I need someone to start now and finish in 3 days. And you would regularly update me.

I would give further details if you indicate interest on this job. Please, only competent programmers should apply as I just came out of a long arbitration delay.

I would like this to be done on time and on budget.

Thanks