Project_1902040002

Hello,

I have few requests of modifying 1 pre-made indicator to work properly as I described here

Firstly, take a look at below image, please.

As you can see, there are 20 buffers in data window.

And there is red colored rectangle in data window.

Firstly, remove the buffers in red rectangle, please.

Then, it will show 16 buffers in data window.

Here, I hope to add extra 4 buffers for “Turncoat Res” and “Turncoat Sup” in the end of buffer list.

New indicator will have buffers as followings below.

v1   Common Top Box Upper

v2   Common Top Box Lower

v3   Common Bottom Box Upper

v4   Common Bottom Box Lower

v5   Weak Top Box Upper

v6   Weak Top Box Lower

v7   Weak Bottom Box Upper

v8   Weak Bottom Box Lower

v9   Untested Top Box Upper

v10  Untested Top Box Lower

v11  Untested Bottom Box Upper

v12  Untested Bottom Box Lower

v13  Verified Top Box Upper

v14  Verified Top Box Lower

v15  Verified Bottom Box Upper

v16  Verified Bottom Box Lower

v17  Turncoat Top Box Upper

v18  Turncoat Top Box Lower

v19  Turncoat Bottom Box Upper

v20  Turncoat Bottom Box Lower

As you can see, there are 4 extra buffers likely as “Turncoat Top Box Upper”, Turncoat Top Box Lower”, “Turncoat Bottom Box Upper” and “Turncoat Bottom Box Lower”.

Here, “Turncoat Top Box Upper”, Turncoat Top Box Lower” will have numerical value in each buffer when “Turncoat Res” happened on current candle.

And also, “Turncoat Bottom Box Upper” and “Turncoat Bottom Box Lower” will have “0.00000” respectively in data window.

In other wise, “Turncoat Bottom Box Upper”, Turncoat Bottom Box Lower” will have numerical value in each buffer when “Turncoat Sup” happened on current candle.

And also, “Turncoat Top Box Upper” and “Turncoat Top Box Lower” will have “0.00000” respectively in data window.

And set “zone_show_turncoat” to “True” as a default setting, please.

Below contents are for 2nd request.

Take a look at below image for the details, please.

As you can see, there is a function of MTF.

Hope you to remove this function in parameter, and also in the code.

And there is a blank when “DnTrend Stop” has a numerical value.

At this time, v1 (UpTrend Stop) should show “0.00000” in data window.

For more details, take a look at my attached document, please.

Thanks in advance,

David