Grail indicators - page 12

 
avtomat:


I will make such changes.

.

But maybe there is something to it after all... Maybe we shouldn't change the integration limits... We'll see.


Then the normalisation conditions will not be met, and if you ignore this, it is perfectly possible to keep the integration limits.
 
avtomat:

We note a very interesting behaviour of the function B(c), the transition process of which takes place in the area of negative values. Figuratively speaking, the future is already conceived, developing, preparing to enter the real world, but not yet manifested in it.

This is the most important conclusion, fundamentally changing our ideas about dynamic processes. The future is predetermined and that is why one believes so piously in God. God is B(c). Or rather, God, if there is one, creates the B(c) function through H(c) and P(c). Past, present and future are rigidly linked by the ratio P+H+B=1. The present is a particle between the past and the future. But it does exist. When integrating the E-function, it decomposes into a diffeomorphic (singular, because it is always necessary to put t=1) H-function and an integral P-function.
 

Results with modified integration limits

.

 
avtomat:

Results with modified integration limits

.

Dear avtomat, good afternoon.

Could you, apart from formulas and graphs, write the conclusions in words.

For those less versed in the matter.

 
Stells:

Dear avtomat, good afternoon.

Apart from formulas and graphs, could you please write your conclusions in words?

For those less versed in the matter.


It is too early to draw conclusions; you have to work up the material to draw conclusions. But small comments are possible, of course.
 
Stells:

Dear avtomat, good afternoon.

Apart from formulas and graphs, could you please write your conclusions in words?

For those less versed in the matter.

Practical conclusions for trading from the action of the formulas can be drawn by analysing an example of a tester run of an algorithm based on them https://www.mql5.com/ru/forum/146732/page9. A 70% stat advantage is obtained, as other factors and parameters remain constant. It is impossible to fully predict the market for known reasons. A roughly two-day market phase has been detected, why it is a two-day phase remains a mystery. 210 bars on M15, 104 on M30 and 52 on H1.
 

.

.

In the modified integration limits, the transient B(c) has lost its negative region. Is this good or bad? What is the physical meaning of such an area?

One should also remember that the Euler Gamma function used in this model is a complex function.

Recall the active and reactive power components. It is too early to confirm, but it seems that the above-mentioned negative region corresponds to the reactive component. Thus, by limiting the integration limits, we cut off the reactive component, leaving only the active component to be considered. However, this significantly impoverishes the model, as the reactive component is just as real as the active component, although it has a different form of manifestation.

 
avtomat:

.

.

In the modified integration limits, the transient B(c) has lost its negative region. Is this good or bad? What is the physical meaning of such an area?

One should also remember that the Euler Gamma function used in this model is a complex function.

Recall the active and reactive power components. It is too early to confirm, but it seems that the above-mentioned negative region corresponds to the reactive component. Thus, by limiting the integration limits, we cut off the reactive component, leaving only the active component to be considered. However, this significantly impoverishes the model, as the reactive component is just as real as the active component, although it has a different form of manifestation.

It should be assumed that we are considering one real process and the sum of all functions describing it should always give one, which is the case. I'm sure, although I haven't checked, that something similar should be obtained in the complex domain.
 
yosuf:

Take the integration limits as 0 - t/t, then E and B(c) will vary between 0-1. The reason for the appearance of (-2) is this.

Performed check: E(c) = P(c) + H(c)?



1)

.

2)

 
yosuf:
A roughly two-day market phase is revealed, why it is a two-day phase remains a mystery. 210 bars on M15, 104 on M30, 52 on H1.
What does the two-day phase mean and what are the numbers 210 bars on M15, 104 on M30, 52 on H1 ?