TickValue must be multiplied by 10 ?

New comment
 
If digits = 3 or idigits = 5, then
double TickValue = SymbolInfoDouble(Symbol(), SYMBOL_TRADE_TICK_VALUE,);
then TickValue must be multiplied by 10 after this?
Or is it already multiplied by 10?
 

You are confusing a PIP vs tick vs point. Value = distance * tickValue / tickSize * lots.

  1. PIP, Point, or Tick are all different in general.
              What is a TICK? - MQL4 programming forum (2014)

    Unless you manually adjust your SL/TP for each separate symbol, using Point means code breaks on 4 digit brokers, exotics (e.g. USDZAR where spread is over 500 points), and metals. Compute what a PIP is and use it, not points.
              How to manage JPY pairs with parameters? - MQL4 programming forum (2017)
              Slippage defined in index points - Expert Advisors and Automated Trading - MQL5 programming forum (2018)

    1. Risk depends on your initial stop loss, lot size, and the value of the symbol. It does not depend on margin and leverage. No SL means you have infinite risk. Never risk more than a small percentage of your trading funds, certainly less than 2% per trade, 6% total.

      1. You place the stop where it needs to be — where the reason for the trade is no longer valid. E.g. trading a support bounce, the stop goes below the support.

      2. AccountBalance * percent/100 = RISK = OrderLots * (|OrderOpenPrice - OrderStopLoss| * DeltaPerLot + CommissionPerLot) (Note OOP-OSL includes the spread, and DeltaPerLot is usually around $10/PIP but it takes account of the exchange rates of the pair vs. your account currency.)

      3. Do NOT use TickValue by itself - DeltaPerLot and verify that MODE_TICKVALUE is returning a value in your deposit currency, as promised by the documentation, or whether it is returning a value in the instrument's base currency.
                  MODE_TICKVALUE is not reliable on non-fx instruments with many brokers - MQL4 programming forum (2017)
                  Is there an universal solution for Tick value? - Currency Pairs - General - MQL5 programming forum (2018)
                  Lot value calculation off by a factor of 100 - MQL5 programming forum (2019)

      4. You must normalize lots properly and check against min and max.

      5. You must also check FreeMargin to avoid stop out

      6. For MT5, see 'Money Fixed Risk' - MQL5 Code Base (2017)

      Most pairs are worth about $10 per PIP. A $5 risk with a (very small) 5 PIP SL is $5/$10/5 or 0.1 Lots maximum.

New comment